Fuente: Polymers Polymers, Vol. 17, Pages 3228: Development of 3D Printing Filament from Poly(Lactic Acid) and Cassava Pulp Composite with Epoxy Compatibilizer
Polymers doi: 10.3390/polym17233228
Authors:
Thidarat Kanthiya
Pattraporn Changsuwan
Krittameth Kiattipornpithak
Pornchai Rachtanapun
Sarinthip Thanakkasaranee
Pensak Jantrawut
Nuttapol Tanadchangsaeng
Patnarin Worajittiphon
Thorsak Kittikorn
Kittisak Jantanasakulwong

A 3D printing filament was fabricated from poly(lactic acid) (PLA), cassava pulp (CP), and epoxy using a twin-screw extruder. Several bio-composites were synthesized by varying the amount of epoxy (0.5, 1.0, 3.0, 5.0, and 10.0 wt.%). The size of the CP fibers significantly affected the surface quality, filament diameter, and mechanical properties of the final product. The smallest fiber size (45 µm) provided a smooth surface and consistent diameter. Incorporating 1 wt.% of epoxy into PLA/CP enhanced the tensile strength (56.6 MPa), elongation at break (6.2%), and hydrophobicity of the composite. The composite mechanical properties deteriorated at epoxy contents above 1 wt.% due to the amplified plasticizer effect of excessive epoxy. The optimized PLA/CP/epoxy formulation was used to generate the 3D filament. The resultant filament displayed a tensile strength of 64.6 MPa and elongation at break of 9.8%, attributed to the fine morphology achieved via thorough mixing provided by the twin-screw extruder. Epoxide-mediated crosslinking between PLA and CP enabled the development of a novel 3D printing filament with excellent mechanical properties. This research illustrates how agricultural residues can be upcycled into high-performance biomaterials with innovation in sustainable manufacturing, inclusive economic growth, reducing reliance on petroleum-based plastics and thus providing benefits regarding human health, climate change mitigation, plastic in the ocean, and environmental impacts.