Fecha de publicación: 29/11/2024 Fuente: Polymers Polymers, Vol. 16, Pages 3354: Fused Filament Fabrication of Slow-Crystallizing Polyaryletherketones: Crystallinity and Mechanical Properties Linked to Processing and Post-Treatment Parameters
Polymers doi: 10.3390/polym16233354
Authors:
Lucía Doyle
Xabier Pérez-Ferrero
Javier García-Molleja
Ricardo Losada
Pablo Romero-Rodríguez
Juan P. Fernández-Blázquez

Recent advancements in thermoplastics within the polyaryletherketone (PAEK) family have enhanced additive manufacturing (AM) potential in fields like aerospace and defense. Polyetheretherketone (PEEK), the best-studied PAEK, faces limitations in AM due to its fast crystallization, which causes poor inter-filament bonding and warping. This study investigated alternative, slow-crystallizing PAEK polymers: polyetherketoneketone (PEKK-A) and AM-200, a PEEK-based copolymer. Both can be printed in an amorphous state and then annealed to improve crystallinity and mechanical properties. Despite their potential, these materials have been minimally explored for AM. Our analysis compared the mechanical performance of as-printed and annealed samples and showed that slow-crystallizing PAEKs outperform fast-crystallizing PEEK. As-printed PEKK-A and AM-200 parts reached tensile strengths of 69 MPa and 47 MPa, respectively, which are about 80% of the values for injection-molded parts. In contrast, PEEK achieves only 25% due to poor inter-layer bonding. Annealing increased crystallinity (15.7% for PEKK-A, 19% for AM-200), simultaneously leading to a coalescence of smaller pores into larger ones, which affected mechanical integrity. Annealing strengthened the printed filament direction, while Z-direction strength remained limited by interlayer adhesion. Our work provides new insights into optimizing these relationships to expand the applicability of PAEK in additive manufacturing.